Flashing Firmware to Creality CR-10 S5
There are plenty of firmware flashing guides out there for CR-10 models, but not yet a lot for the CR-10 S5 model. So I had to figure out how to flash the firmware based on what was available for other models. To understand what is required, please refer to this video. It has all of the major steps needed. This post is not meant as a full guide. It's merely supplemental information that applies to the video below meant for the S5 model's of the CR-10 series. https://www.youtube.com/watch?v=7J7NYnxL5vA So the basic idea is the CR-10's do NOT have a bootloader installed by default. So in order to flash the firmware, you first have to burn the bootloader. This can be done via an arduino because the CR-10's all use an arduino as their main processor. The CR-10 normally has a jumper to switch to USB power. the S5 does not have this. You can just disconnect the 120/240v power and plug in the USB cable and it will power the S5 board. You wil need the boar